12IN TX3 FAN POWER SPLITTER
|
50%
40%
10%
0%
0%
|
 Rating: Review Date: 10/16/11 |
12IN TX3 FAN POWER SPLITTER
Cons:none really
Pros:Permits te use of 2 fans from one power header. |
|
Rating: Review Date: 04/07/11 |
12IN TX3 FAN POWER SPLITTER
Cons:
not sleeved, ugly
Pros: Does the job perfectly Comment:
does the job perfectly, should be sleeved tho. kinda ugly. |
|
Rating: Review Date: 02/23/11 |
12IN TX3 FAN POWER SPLITTER
Cons:
No sleeving.
Pros: Performs its purpose perfectly. Comment:
Does its' job perfectly. Easily allows you to connect multiple fans together and not that expensive. |
|
Rating: Review Date: 01/21/11 |
12IN TX3 FAN POWER SPLITTER
Cons:
Cables A Little Long
Pros: CheapReliable Comment:
This cheap device allowed me to have multiple fans via motherboard connector. Can be PM'd to $1.99.Highly recommended.I threw a bunch of Noctua fans into my system and didn't want to use the PSU power connector. |
|
Rating: Review Date: 01/14/11 |
12IN TX3 FAN POWER SPLITTER
Cons:
-Little expensive for what they are-No black sleeve on wires
Pros: -They work great Comment:
They work as I needed them to so I can't complain. My case also has great cable management so I was able to keep these out of sight, which is good because they wires are not in a black sleeve. Would order again, they do their job good. |
|
Rating: Review Date: 01/04/11 |
12IN TX3 FAN POWER SPLITTER
Cons:
None.
Pros: Very handy!Does what is advertised.Cheap. Comment:
These are great for connecting multiple fans to a fan controller. You can daisy chan these together to connect as many fans as you want. ie- 2 of these gives you enough connecters for 3 fans. I have a 2 channel fan controller so I used one of these splitters to connect my two rear exhaust fans to one side of the controller, then daisy chaned 2 more together to connect my 3 intake fans to the controllers other channel. I just wish I knew these existed a long time ago, would have saved me butchering the wire harnesses on many fans over the years...lol! |
|
Rating: Review Date: 11/15/10 |
12IN TX3 FAN POWER SPLITTER
Cons:
ugly
Pros: it worksgood quality Comment:
It's a basic fan splitter that works. Plugs into any 3 pin fan header and runs them fine. I have it splitting two fans on a cool it vantage for a push/pull config and this splitter works great. I would definitely buy it again if I ever neen another splitter. It's too bad its unsleeved though, so it isn't the prettiest thing |
|
Rating: Review Date: 10/17/10 |
12IN TX3 FAN POWER SPLITTER
Cons:
Ugly (but usually will be behind the mobo tray), so its not a big deal.
Pros: Flexibility, length and purpose it serves Comment:
These are working great for why I bought them. Using for splitting 1 channel on my fan controller to 2 fans each. Works like a charm, just remember to remove the yellow wire from all but the 1 fan you want to measure rpm. I even combined 2 of these so that I could use 3 fans on 1 fan control channel.Note: Check wattages of channels, and fans before attempting. Also, best to use same fans on 1 channel and also safe to leave 1-2 watts headroom on each channel. |
|
Rating: Review Date: 08/30/10 |
12IN TX3 FAN POWER SPLITTER
Cons:
none.
Pros: works well, reduce cable clutter. Comment:
try to pm this. it works well and helps reduce the need for multiple molex adaptors. although it says 12inch, the length is actually 6inch, two 6inch power output extending from one input. |
|
Rating: Review Date: 04/28/10 |
12IN TX3 FAN POWER SPLITTER
Cons:
none
Pros: Good quality construction. Had no problem plugging in to anything like others i have used in the past. Comment:
These things are great.Good quality construction. Had no problem plugging in to anything like others i have used in the past. |
OK it would be nice if they were sleved but I knew they weren't so I can't complain. They do what I wanted which is to use one poer header off my fan controller to power/adjust 2 fans at the same time.