Mustang Projector Spider Ceiling Mount

Comment:
Mine looked like it had been rebuilt. The big adjust ment screws were painted over with an epoxy paint and the mount was almost impossible to disassemble to put together. Did I get a return? The level of the projector is achieved by placing a series of washers to the body and of course cannot be tested until on the ceiling. This took about three hours and I thought it would be a turn key type of project. Overall my satisfaction level is a three out of ten as the projector is up but movement is limited to up and down, left and right. It is not adjustable on three axis.

Comment:
I bought a similar device for $119. For $79. this is just as good and just as versatile. This is the second one I've purchased and will buy two more.

Comment:
Wide range of applicability - this will literally work with just about any projector. I was amazed it even had the right screws for my machine! Very easy to use. I loved this mount!

Comment:
I was a bit concerned the mount would do the job but with a little figuring I was able to make it work. I was mounting a Optoma H31 and 3mm screws and washers required for attaching the projector to do not come with the mount. Optoma is a large mfg. and I would expect Mustang to supply them. But other than that the mount is a fine value for the money. Way to go Tiger!