OKGEAR 10" SATA 6Gb/s round cable, straight to right angle

Comment:
good seeking and operating cables, do what they're suppose to. none Alittle widespread sense and a utility knif to trim the roundness of oneside of the connector and your in organization-took a additional 20 seconds, extremely delighted with outcomes

Comment:
The color. The cable itself is somewhat stiff which tends to make it challenging to route the cable. The ends is what got me. They have a rounded finish which sticks out so that you can not use yet another one of these cables side by side on your MOBO. I have 6 SATA slots on my MOBO and if I use these cables, I can only use three. I could use a flat SATA cable but I would almost have to force in and Im not taking that opportunity. Absolutely nothing seriously wrong with this cable except the protruding rounded finish to it. I just bought the same cable but the flat version rather.System SPECS:I7 980X three.33GHZASUS P6T7 SUPERCOMPUTER MOBOtwo X 600GB VELOCIRAPTORStwo X 2TB WD CAVIAR BLACK24GB KINGSTON HYPERX MEMORY WITH HYPERX FANANTEC 1200W HIGH Current PRO PSUEVGA GTX 580 SUPERCLOCKED ( WAITING FOR 590'S, WILL GET 2 IF I CAN )ANTEC LANBOY BLUE Case ( 13 FANS/COOLERMASTER 120MM )KILLER PRO NIC

Comment:
Well Produced, Nice Searching. They appear to be of superior quality. I have these 18" cables as nicely. A reviewer of the 18” cables stated that these cables didn’t play nicely with stacked Sata connectors, so I contacted Okgear to see if they had rectified the situation. I was told “problem connector is from old version”, sadly this was not true. The protrusion on the straight connector forces them to plug into the MoBo connector at an angle. Also whilst plugged into the stacked connector the upper cable depressed against the release of the lower cable causing it to not lock in. I have two DVDs and two difficult drives and had no trouble plugging these cable in subsequent to my power cable as somebody else statedThe metal clip on the end fell off but I was able to put it back on

Comment:
Did my study and measuring, this was just the suitable length and had the needed angle for my construct, was not high-priced. Is just a hair bigger than most SATA cables I have used in the past. Hey, you want this cable! Just make confident you appear at the picture so you can get the right angle for the job. I utilised this in a Rosewill Challenger case for the HD mount and it worked like a charm, well pretty much. If you look carefully at the picture you'll notice the blue plastic cover is slightly wider than the connector, this causes the connector to bend slightly when the energy supply cable is appropriate subsequent to it. It still went in and I had no transfer problems but if I'm going to particular order a cable I anticipate a far better fit than this.