Primochill Polypropylene 1/2IN OD to 3/8IN OD Barb to Barb Reducer
|
60%
40%
0%
0%
0%
|
 Rating: Review Date: 04/27/11 |
Primochill Polypropylene 1/2IN OD to 3/8IN OD Barb to Barb Reducer
Cons:
they not pretty but its easy to hide them.
Pros: they are easy to use, seal very well, good for adapting 2 size hoses |
|
Rating: Review Date: 08/13/09 |
Primochill Polypropylene 1/2IN OD to 3/8IN OD Barb to Barb Reducer
Cons:polypropylene look awfull IMO.
Pros:Do the job well. Comment:
Do the job well, reduce the 1/2 to 3/8. No restriction since you already change tubing size so your restriction will be your actual setup since your not supposed to change tubing size in the middle of a loop... |
|
Rating: Review Date: 11/19/08 |
Primochill Polypropylene 1/2IN OD to 3/8IN OD Barb to Barb Reducer
Cons:Nothing
Pros:Works, looks ok and it is UV reactive Comment:
These work great and it looks like they will hold out for a long time. Although in my loop it created a pocket of air before the 1/2 end. It went away after some bleeding so it's all good. |
|
Rating: Review Date: 07/05/08 |
Primochill Polypropylene 1/2IN OD to 3/8IN OD Barb to Barb Reducer
Cons:None so far.
Pros:* Looks decent* Hasn't leaked so far* Most important: Works. Comment:
Used it to connect my 1/2" loop to my single 120 rad which came with 3/8" barbs only. Works flawlessly, fits tightly and hasn't leaked so far. Would buy again. |
|
Rating: Review Date: 06/13/08 |
Primochill Polypropylene 1/2IN OD to 3/8IN OD Barb to Barb Reducer
Cons:platic Fitting
Pros:Decent quality, Comment:
Had to combine some 1/3 and 3/8 inch tubing, this stuff does the trick. Looks OK enough, and design ensures a tight fit and no leaks. |
i bought these because i had to adapt my 1/2" loop to my 3/8" barbs on the zalman zw-gb5 water block they are awsome they seal very well, and they are easy to hide behind drive bays.