Zalman Z12PLUS ATX Mid Tower Case w/ Side Window & MULTI-FAN Cooling Wide Band MESH Front Vent USB 3
|
0%
100%
0%
0%
0%
|
 Rating: Review Date: 12/23/13 |
Zalman Z12PLUS ATX Mid Tower Case w/ Side Window & MULTI-FAN Cooling Wide Band MESH Front Vent USB 3
Cons:hard to remove front and top coverneed to buy filters to replacestock fans seem to not pull a lot of air
Pros:Side windowsolid look and build |
|
Rating: Review Date: 08/24/13 |
Zalman Z12PLUS ATX Mid Tower Case w/ Side Window & MULTI-FAN Cooling Wide Band MESH Front Vent USB 3
Cons:see summary
Pros:Price, features, build, window, cooling Comment:
This was a really nice case... I was surprised for the price (I paid $59.99) what I got. Black inside and out, nice window, a couple of good 120mm fans (1 LED), lots of build room, USB 3.0 in charging tray, etc.. The all-around look was slick, build was decent for this price range. Loots of cooling options, but my one gripe was that after installing a standard ATX PSU I was unable to mount a fan on the bottom with either 120mm or 140mm options. I don't know how that fan mount could be used otherwise. Other than that, highly recommended, would buy again. |
|
Rating: Review Date: 07/15/13 |
Zalman Z12PLUS ATX Mid Tower Case w/ Side Window & MULTI-FAN Cooling Wide Band MESH Front Vent USB 3
Cons:The plastic pins holding the top of the case are flimsy. I broke easely two of them when I tried opening it to add another fan.
Pros:Nice finish, big side window , 2 speeds fan controller built-in (for front and top only), dust filters for intakefans, front mesh for better ventilation, supports 240mm rad for liquid cooling. Comment:
It's a very good case for this price range (under $80 or less when on sale).Technical specs says 'tool-free Hard Drive installation' but you need a screwdriver to bolt the anti-vibration rubber on the disk. The dust filters for the fans are hard to remove and to clip back in place. So I replaced them with magnetic filters. This review was modfied by poster @ 07-15-13 07:09 PM |
overall this is a good case. the plastic parts that are matte looks like the metal part and it looks solid.good fore negative air pressure. probably not ideal for positive air pressure because front and back could leak air