nGear 3 Pin Male Fan to 4 Pin Male Molex Power Adapter Cable
|
100%
0%
0%
0%
0%
|
 Rating: Review Date: 12/22/14 |
nGear 3 Pin Male Fan to 4 Pin Male Molex Power Adapter Cable
Cons:None
Pros:Cheap (pricematch)Well built |
|
Rating: Review Date: 08/18/12 |
nGear 3 Pin Male Fan to 4 Pin Male Molex Power Adapter Cable
Cons:No issues
Pros:Does what it says it does Comment:
Had no issues with it yet. Didn't burst into flames or melt inside the case yet so that is a good sign. Its a cord so thers's not much that can go wrong unless you are frequently moving it, which I'm not. Would buy again. |
|
Rating: Review Date: 06/20/12 |
nGear 3 Pin Male Fan to 4 Pin Male Molex Power Adapter Cable
Cons:- Nothing to say, it just works.
Pros:- Price-matched at 1.77$! Comment:
Impossible to find for cheaper anywhere. Really worth it! The fan controller in the Corsair 650D of my cosin died within 6 months so to power his front fan I needed to buy him this. |
|
Rating: Review Date: 06/08/12 |
nGear 3 Pin Male Fan to 4 Pin Male Molex Power Adapter Cable
Cons:None
Pros:Does what it says it does Comment:
What can I say, it does what it says it does and it works fine.It's for when you have a fan with a Molex connector and you want to plug it into a motherboard header so you can monitor the speed. It will work the other way too, if you have a fan with a 3-pin connector and don't have enough motherboard headers but a spare Molex plug coming out of your power supply, you can use this.All it does is connect the two ground pins and the +12V pin on the 3-pin fan header to the two ground pins and the +12V pin on a Molex connector.I'm using it with an old Antec power supply that has dedicated low-voltage Molex connectors. I connected one of these to this adapter then to a 3-pin fan. Works perfectly. |
Pretty simple item, nothing complex about it. Very handy to have around.